by being secured to the top using two wing nut bolts and two wing nuts fastened
through the outside bridge pin holes. Once the bridge has been properly located the
two BP holes need to be drilled using a 3/16 “ bit. We highly recommend using our
“Bridge Setter”© tool for this operation.
in addition to the outside bridge pin
holes.
taped to the end of the bridge to
prevent the clamp from scratching the
surface.
with bar soap or candle wax to
prevent gluing them to the guitar.
Place the “SS Bridge Clamp”© on the
bridge, locate the clamp and the
bridge, through the top using the wing
bolts. Notice the clearance holes for
the saddle position locating pins.
the sound hole and the wing bolts
tightened from above.
two out side bolts are gently screwed
down. Glue squeeze-out should appear
all the way around the bridge. Now is
the part where the “SS Bridge Clamp”©
really shines --- the glue squeeze-out
can be completely cleaned up since
there are no obstructions like other
clamping methods
the clamp.